05-1603 Debris Reduction - Laserfiche WebLink

Home Browse Search

than 2 feet in diameter will be disposed of by either splitting and burning, or chipping/grinding. The method will be at the discretion of the Contractor. 3.6 Ash. Ash is the residue produced by incineration of the burnable debris. When handling ash, it will be required to "wet down" the ash to prevent dust problems. 3.7 ChipslMulch. Chips and mulch are the end product of chipping or grinding wood products. Proper disposal of chips and mulch is to find environmentally friendly (non- landfill disposal) use for the material. 4. PERFORMANCE SCHEDULE. 4.1 Immediately following Bid Opening, the apparent low bidder will meet with the CITY to discuss matters of judgment, safety, quality control, coordination, payment, record keeping, and reporting. 4.2 Schedule. The Contractor shall begin preparation for mobilization immediately after Notice to Proceed and be fully operational within 120 hours after Notice to Proceed. 4.3 Production. The Contractor is required to process a minimum of ISO to 180 CY per hour, cubic yards of debris per calendar day. The minimum required reduction/disposal rate shall be achieved no later than the second calendar day after receipt of Notice to Proceed. This minimum production rate is increased to 180 to 210 CY per hour in the event that the City exercises the option for additional reduction capacity. 4.4 Completion. All work, including site restoration prior to close-out, shall be completed within ten (10) calendar days after receiving notice rrom the CITY that the last load of debris has been delivered, unless the City initiates additions or deletions to the contract by both parties pursuant to applicable State and Federal law. 5. EQUIPMENT. 5.1 The contractor shall provide all equipment necessary to prepare the site, stockpile the debris, feed the air curtain incinerator(s), remove ash rrom the incinerator(s), load and haul for disposal all non-burnable debris and ash residue, and any other equipment which may be necessary for the perfonuance of this contract. The Contractor shall comply with local, tribal, State and Federal safety and health requirements. 5.2 All equipment must be in compliance with all applicable Federal, State, tribal and local rules and regulations. All equipment and operator qualifications will meet the requirements of local, tribal, State and federal safety and health requirements. The contractor using the applicable inspection fonus will inspect equipment prior to its use. The completed fonus will be provided to the City. 5.3 Prior to commencing debris reduction and disposal operations, the Contractor shall present to the Contracting Officer or his representative, the CITY, for approval, a detailed Scope of Work - Reduction & Site Management May 2005 Page 3 of 14